Revel Voice 2 Manuel d'utilisateur télécharger pdf (Page 21)

Ultima Voice2

Owner’s Manual

VERTICAL BI-AMPLIFIED

Vertical bi-amplified connections are made between both pairs of

Voice2 input terminals and two separate power amplifier output

channels. Each speaker is connected to its own power amplifier.

The power amplifiers must be identical. Vertical bi-amplified

connections are shown in Figure 13.

To make vertical bi-amplified connections:

1. Remove the jumper straps identified in Figure 3.

2. Connect one pair of loudspeaker wires to the high frequency

pair of Voice2 input terminals. Then connect the same pair of

loudspeaker wires to the desired power amplifier output

channel.

3. Connect another pair of loudspeaker wires to the

low-frequency pair of Voice2 input terminals. Then connect

the same pair of loudspeaker wires to a separate output

channel on the same power amplifier.

4. Make sure that all terminals are firmly hand-tightened.

Figure 13: Vertical Bi-Amplified Connections

Note

When making vertical bi-amplified connections, both power

amplifiers must receive identical input signals from the associated

preamplifier. A “Y” adaptor is required if the associated preamplifier

does not offer two connectors per output channel. Otherwise, each

power amplifier can be connected to a separate connector for the

same output channel of the preamplifier.

Note

Vertical bi-amplified connections must be made using two identical

power amplifiers.

Voice2

OUTPUT 1

POWER

AMPLIFIER 1

OUTPUT 2

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Pas de commentaire

Revel Voice 2 Manuel d'utilisateur Page 21