Revel M22 Pedestal Manuel d'utilisateur télécharger pdf

The large tube and bottom

base feature wire access

holes through which speak-

er wires can be threaded and

concealed from view. Thread

the end of the speaker wire

into the pedestal through

the top hole at the rear of

the large tube and back out

through the hole at the

bottom base.

Performa Pedestal 22

Assembly Instructions

There are different size

threads on each end of the

tube(s). Make sure that the

end attached to the top

plate properly fits the

6mm x 18mm screws before

attempting to tighten. It is

not possible to attach the

wrong end to the top plate,

as the threads at the bottom

end will not fit the

6mm x 18mm screws.

Step 1: Locate the parts bag (packed with the stand) that

contains spikes, screws, lock nuts, Allen wrench and

hole plugs. Set all parts aside.

Step 2: Begin the stand assembly by fastening the three tubes

to the top plate with three enclosed 6mm x 18mm

Phillips flat head screws. Start all screws by hand before

tightening with a screwdriver.

Step 3: Place the stand upside-down and install the

bottom base with three 8mm x 20mm hex cap screws

using the Allen wrench (included).

Step 4: With the stand upside-down as shown below, install the

spikes (from Step 1) to the bottom of the base. Thread spikes

about halfway and then use a wrench or pliers to tighten

the locking nuts. Tighten all screws again after stand is fully

assembled. Turn stand upright and adjust spikes if required.

Step 5: Place the Revel Performa M22 loudspeaker as shown onto

a carpeted surface or a soft towel. Attach the assembled stand

with four 8-32 x 3/4 Phillips flat head screws.

(3) 6mm x 18mm

flat head screws

(4) 8-32 x 3/4” flat

head screws

(Start All Screws By Hand

Before Tightening With

Screwdriver)

Revel Performa

Pedestal 22

(Assembled)

Bottom Base

Top Plate

Bottom Base

(1) Large Tube

(2) Smaller Tubes

Top Wire Access

Hole

Bottom Wire

Access Hole

Spike

Lock Nut

(3) 8mm x 20mm hex

cap screws

Top Plate

M22 Loudspeaker

If wires are not thread-

ed through the tube,

use the plugs to seal

the wire access holes.

3 Oak Park Drive, Bedford, MA USA 01730-0413 | Tel: 781-280-0300 | Fax: 781-280-0490 | www.revelspeakers.com | 12/03 | Part No. 352290-001

(Rear)

(Front)

(Rear)

Wire Access Hole

Résumé du contenu

Page 1 - Assembly Instructions

The large tube and bottombase feature wire accessholes through which speak-er wires can be threaded and concealed from view. Threadthe end of the spe

Commentaires sur ces manuels

Pas de commentaire

Revel M22 Pedestal Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Revel M22 Pedestal. Revel M22 Pedestal User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels